Gilson FC 204 Fraction Collector

The Gilson FC 204 Fraction Collector is a compact fraction collector with a large capacity capable of handling test tubes, vials, and up to 9 shallow or deep well microplates. The built-in keypad makes setup and operation simple and capable of interfacing with any HPLC system via contact signals. The FC 204 collects fractions by time, drop, or peak to suit all of your chromatography conditions. (Tube racks are not included with this fraction collector).

All of our equipment is fully tested to perform at factory specifications before being shipped.

INCLUDED:

The Gilson FC 204 Fraction Collector includes:

> Power Cord

> Operator's Manual

> Full 180 Day Parts and Labor Warranty

Gilson FC 204 Fraction Collector Specifications

3-Way Valves :	3-port, PTFE, 114 µL internal volume, 6 µL dead volume from common port to the normally closed port, up to 200 mL/min with standard or large bore needle
Communication Interface :	RS-232 or GSIOC; Inputs for start/advance and end/home; event mark output; one programmable output for control of peripheral devices
Data Acquisition :	An input channel for analog-to-digital conversion; digital data is transmitted on the GSIOC
Detector Input :	±100 mV full scale
Drop Counting :	Up to 9,999 drops per fraction maximum rate: 20 drops/sec
Event Marker :	100 ms pulse
Front Panel :	Two-line, 24-character display on backlit LCD. Five command, HELP, YES, NO and 0–9 numeric hard keys; four soft keys
Maximum Collection Volume/Tube :	32 mL (18 x 180 mm tubes) or 25 mL (18 x 150 mm)
Maximum Fractions :	Up to 768 when configured with eight 96-well, 2-mL Whatman/Polyfiltronics microplates on a Code 17 rack)
Multiple-Column Collection :	Simultaneous collection from up to 18 columns with installation of optional multiple column adaptor(s)
Multiple-Cycle Operation :	Repetitive collection of each sample into same set of tubes or collection of each sample into different set of tubes 3-port, PTFE, 114 mL internal volume, 6 µL dead volume from the common port to the normally closed port, up to 200 mL/min with large bore needle
Number of Racks :	Holds one Code 16 or Code 16D rack, one Code 17 rack, or up to four Code 20-Series racks (all racks must be the same code)
Operating Modes :	Drop, Manual, Peak + Drop, Peak + Time, Time
Peak Detection :	Adaptive-slope algorithm that applies user-specified parameters to accommodate drifting baselines, negative and asymmetrical peaks, or absolute threshold level that collects all peaks above specified mV value Peak parameters: peak height or level, in mV and peak width at half-height, in minutes Minimum peak height for fractionation: 0.1 mV full scale Detector-collector delay: 0.01 minute increments
Power Requirements :	120V, 50/60Hz, 0.5A
Programmable Time Units :	From 0.01 to 99.99 minutes per tube with a 0.01 minute limit of resolution
Time-Based Programming :	Up to 10 collection windows and 10 drain steps in any mode
Tube Change Time :	100—720 ms, center to center, depending on rack type
Dimensions (W x D x H) :	47.9 x 46.4 x 33 cm (18.9 x 18.3 x 13 in.)

Gilson FC-204 Manual

Click Here to View the Technical Specs for the FC-204

Free Shipping

Gilson Fraction Collector

Filter By

Price Range

Listing Type

Condition

Category

Manufacturer

Related Products